There is now a pale blue sky in St Charles, VA! This past week has been “backdrop week” on the layout, and today I finished sanding and painting the blue color on the backdrop. It’s amazing what a difference the backdrop makes in giving shape to the scenes. This is also a big step because it’s one step further than I got with my last layout before I had to tear it down–it’s good to surpass the progress of the previous effort.
The backdrop, like the fascia, is 1/8″ Masonite (or “hardboard” at some stores). I know a lot of modelers like Masonite because of its smoothness and flexibility, but over the years I’ve heard one repeated complaint: “it’s nearly impossible to fill holes and cover seams because nothing will stick to it.” If you’re worried about this, worry no more! I find that lightweight spackling compound (I use DAP Patch-N-Paint) works perfectly on Masonite. A couple of tips. First, make sure you countersink the screw holes so the screw heads are at least 1/32″ below the face of the Masonite to give enough depth for the spackle to work–this is tough to do without going through the 1/8″ board, but don’t worry if you have to patch an extra hole. Next, I apply a layer of the spackle over the screws and across any joints with a plastic putty knife to avoid scratching the Masonite. I clean it up a little with the knife, but messy is ok. After it dries for about 1-2 hours, I use a damp washcloth to scrub off the excess spackle. This usually leaves a bit of a depression in the holes and seams, so I put on a second layer of spackle. After this completely dries, I sand it with 150-grit sandpaper until it’s even with the Masonite surface and wipe it once again with a damp washcloth. Once painted, I have to look very carefully to see the seams, and the screw holes all but disappear.
For the color, I wanted a very light sky blue, enough to look blue but that kind of whitish and hazy blue on the horizon. I stood in Home Depot for 20 minutes with pictures of Appalachian scenes on my phone comparing the color to all the options Behr had to offer. I finally decided on this color in a flat finish (Behr calls it “After Rain”), and I’m pretty happy with it. If anything it’s a little more blue than I’d hoped, but the hue looks pretty natural, and it’s not too dark. Two coats with a roller gave the backdrop a nice even look. The backdrops are all ready to support some scenery forms now.
I must say, I’m going to miss taking pictures of the Mayflower Tipple mock-up with a nice white plastic insulation blanket as the backdrop… ok, no I’m not.